ok so far good cmp ckp signal on scope.replaced anyway. replaced ecm. throws a code for cmp ckp loss of signal at ecm. starts stumbling for two or three minutes and then ultimately dies everytime.NEED HELP GUYS. all is appreciated
1996 dodge intrepid 3.5 stall
Collapse
X
-
Tags: None
-
I would check timing , water pump pulley specially being a 95. -
-
p1391 intermittent loss of cmp or ckp...the cutting out condition was worse but i raised the cmp UP on its adj. and now it only seems to cut out over 3000rpm.i even ordered and installed a chrysler cmp no change.Comment
-
Voltage drop on the signal wire from ckp to ecm is?
Check the grounds to the ecm as well...MasterWrenchComment
-
masterwrench,
haven't seen you on here in awhile. am i not very observant, or were you on a hiatus?
papawrench,
can you upload the cmp/crk file?Comment
-
I Have Been On A Hiatus But No Worries Im Back..to The Man Who Said Water Pump Close...it Was The Tensioner Fine At Idle But Pick Up The Rpm And It Would Colapsecausing A Loose Belt And Timing Advance Thx For The Help Guys...i Have A New Post Look At It I Need Help BaaadddComment
Comment